Becker R40/17C Provozní pokyny

Becker-Antriebe GmbH35764 Sinn/Germanywww.becker-antriebe.comR8/17C PRF+ - R40/17C PRF+Assembly and Operating Instructions Roller Shutter Drives with

10Assembly and Operating Instructions5d)6a)6b)Action Response6b) Increasing the shutter travel distance (the desired limit position is outwith the exi

117a)7b)8a)8b)8c)7) Deleting end limitsNoteThe end limit settings can only be deleted via the master trans-mitter.7a) Deleting the end limits individu

12Assembly and Operating Instructions9b)9a)9c)10)10) Learning additional transmittersNoteIn addition to the master transmitter, up to 15 transmitters

1311a)11b)12a)12) Overwriting the master 11) Deleting transmitters11a) Deleting transmitters individuallyNote The master transmitter which was program

14Assembly and Operating Instructions12b)NoteThis function is only available with the transmitters MemoControl MC441 and MC411 from Becker Centronic c

15Technical DataType R8/17C PRF+ R12/17C PRF+ R20/17C PRF+ R30/17C PRF+ R40/17C PRF+Nominal torque (Nm) 8 12 20 30 37Output speed (min-1) 17 17 17 17

16Assembly and Operating Instructions2010 300 350 0d 10/10Slide the radio switch to po-sition . (The tubular drive goes into learn mod

2Assembly and Operating InstructionsTable of ContentsGeneral ...

3Structural modications and incorrect installation which are not in accordance with these and our other instructions can result in serious injuries,

4Assembly and Operating InstructionsImportant safety instructions for the installation and commissioningCaution! Failure to observe these instructions

5All R8/17C PRF+ to R40/17C PRF+ tubular drives are intended solely for the operation of roller shutters. The tubular drive is t-ted with springs whi

6Assembly and Operating Instructions35Mounting the roller shutter driveAttentionDrives from Becker Antriebe are to be mounted and operated solely wit

7764. The drive adapter of the tubular drive is connected to the roller tube as fol-lows: Size of drive [mm]Roller shutter tubes–Ø [mm]Torque max. [N

8Assembly and Operating Instructions2b)4)1) + 2a)Action Response1) Connecting the tubular driveConnect the tubular drive to the power supply and open

95a)5b)5) Setting the end limitsNoteThe end limits can only be set via the master transmitter. The axle direction setting must be correct. When the en